V-SEAL® 102 Winter Guard Penetrating Sealer and Curing Compound (Broom Finish)

Description

PRODUCT DESCRIPTION
V-SEAL® 102 Winter Guard is a chemically reactive deep penetrating sealer that permanently fuses within porous broom finish concrete and porous concrete block (CMU block). V-SEAL® 102 will significantly increase surface strength, combat freeze/thaw damage, and limit penetration of stains such as oil, gas, grease, and salt. V-SEAL® 102 reduces dusting, retards mold and mildew, restricts efflorescence and hydrostatic moisture, and imparts waterproof characteristics. V-SEAL® 102 is breathable with minimal impact to traction coefficient. V-SEAL® 102 creates a cross-linked insoluble internal membrane barrier that will wear away only if the substrate itself wears away below sealer penetration. V-SEAL® 102 has been tested to exceed ASTM C666 Freeze/Thaw Test 1000+ cycles .0096 (standard 300 cycles .060) and pass ASTM C672 Scaling Resistance Test with no scaling). V-SEAL® 102 meets all criteria of ASTM C156, ASTM C309, and AASHTO M 148 - Liquid Membrane-Forming Curing Compound.
RECOMMENDED USES
Long-term water repellent sealer for existing broom finish concrete and porous concrete block, and liquid membrane-forming curing compound for curing new broom finish concrete. V-SEAL® 102 is recommended for commercial and residential structures such as parking decks, roads, driveways, sidewalks, patios, basements, poured concrete and block walls. This product is suitable for interior and exterior, horizontal and vertical, above and below grade applications. V-SEAL® 102 is compatible with most glues, mastics, and topical coatings.
Coverage Rate
200-300 sq. ft. per gallon broom finish/rough 150-300 sq. ft. per gallon porous block *Coverage rate is for estimating purposes only. Application rate is based upon porosity and absorption. Always test absorption prior to application. When properly applied product should create a wet surface sheen and absorb within 1 minute without puddles. Immediately disperse puddles. Excessive application may result in white residue which will not affect sealer performance and generally dissipates over time, but may removed immediately with abrasion.
Drying Time
Dry to touch 1-3 hours, traffic 6-12 hours. Inclement weather should be avoided for at least 12 hours. **Drying time is for estimating purposes only.