Pneumatic Sand Blasting Spray Gun Portable 4 Nozzle Tips Kits Equipment Supplies

Description

Pneumatic Sand Blasting Spray Gun Portable 4 Nozzle Tips Kits Equipment Supplies
Features
:
Install a male 1/4'' NPT pipe fees nipple of your choice in the handle base. Teflon tape is recommeded to prevent air leaks. Do not over tighten, or there is the possibility of stripping the steel insert, or the gun handle
Make sure the air line is disconncted.
Make sure the air delivered is clean and especially dry. No sand Blaster will work effectively with moisture laden air, UNIT WILL NOT WORK CORRECTLY OVER 125PSI.
Open sand flow valve to desired position. Place ceramic nozzle at a comfortable distance from part to be sand blasted, approximately 6 to 24 inches is recommended.
TROUBLE SHOOTING
Sand Flow Stops
Air delivered may contain moisture. Make sure a proper water separator is installed.
Check air pressure (Minimum 60PSI required) .
Remeve front clip on reservoit, lift and swing reservoir slightly and check orifice in material control valve. If obstructed, remove debris and reassemble.
Make sure the nozzle is fully tightened(Hand Tighten only).
Remove nozzle to see if the steel insert is lost or missing. HAND HELD SAND BLASTER WILL NOT WORK WITHOUT THE STEEL INSERT IN PLACE.
Sand Pattern Erratic:
Air delivered may contain misture. Make sure a proper water separator is installed.
Sand blast media has inconsistent particle sizes and must be strained. Use a small pattem screen with maximum 1/16" openings.
Nozzle is worn and must be replaced.
STEEL INSERT IS WORN OR LOST.
Package includes:
1 x Sand Blasting Spray Gun