Engine Intake Valve Cleaner Dry Ice Blaster Carbon Deposit Fuel System Cleaning

Description

What is carbon deposition?
There are some hydrocarbon olefin residues attach on engine intake,cylinder when fuel burn in engine not completely. These residues change into hard black shell in high temperature condition, that called carbon deposition.
Why need clean carbon deposition?
Carbon deposition will decrease air-fuel ratio, cut down engine output power, increase fuel consumption, engine drastic shake on idle status...all the thing will hurt engine deeply. So normally we should clean carbon deposition after every 40000-50000 kilometer trip.
What is dry ice cleaning machine?
AUTOOL HTS708 is a cleaning machine applied in the field of automotive servicing, in which the dry ice particles are accelerated by the airflow at high speed to remove the carbon buildup. The cleaned dry ice will vaporize in the ambient, which is safe and residue-free and will not damage the vehicle.  It can be used for the cleaning of carbon deposits in the engine compartment, cylinder combustion chamber, intake valve, throttle valve, and etc.
The Main Features of AUTOOL HTS708:
1.[High High-Efficiency Cleaning]: It adopts dry ice cleaning tech, which accelerates the dry ice particles through high-pressure airflow and impacts the deposits, thus removing the carbon buildup thoroughly. It can fully clean the carbon deposits in all vehicle parts without disassembling them as well. This effectively reduces the cleaning time and greatly improves efficiency.
2.[Eco-friendly & Safety]: Dry ice particles will sublimate and gasify without leaving a mess after cleaning, which greatly save your time and labor-free; it is eco-friendly that will keep equipment safe.
3.[Intelligent Control Panel]: AUTOOL HTS708 Dry Ice Blasting machine is designed with an Intelligent microcomputer inside, which can precisely control the pressure. It can be optimally adapted to the cleaning task due to its adjustable control for air pressure and ice rate.
4.[Widely Used]: AUTOOL HTS708 Dry Ice Blasting machine is ideally suited for wide applications in automobiles, electric power, rubber, plastic, chemical, printing, food, pharmaceutical, casting, ship, and aviation.
5.[Three Years Warranty, Lifetime Maintenance]: For damage caused by non-human factors, AUTOOL promises to resend parts for free within 3 years. For any needs, you are warmly welcomed to contact us and we will get back to you ASAP within 24 hours.
Applicable fields:
Dry ice blast cleaners are widely used in fields such as rubber, casting, automobiles, ships, electric power, chemicals, printing, plastics, food, pharmaceuticals, and aviation.
Specifications:
Technical parameter Power supply: AC110V/220V±10% 50Hz
Dry ice capacity: 7.5KG
Compressed air flow: >1~2.03/min
State of dry ice particles: 3mm
Air supply pressure: 0.3~1.0Mpa
Dry ice blasting amount (adjustable): 0~3.2Kg/min
Size: 500mm*450mm*800mm
Net weight: 49KG
Gross weight: 80KG
How to use?
After the cleaning work:
1. Turn the controller knob of the dry ice amount to the "0" position and turn on the blasting gun for 30-50s until no water is blasted out.
2. Turn the knob controller to the cleaning mode, and the equipment will clean the dry ice residue by itself. Manual cleaning is required if necessary.
3.Disconnect the power switch and air source, and put away the blasting gun and accessories.
Package include:
1pc* AUTOOL HTS708 Dry Ice Blasting machine main unit
1pc* Shovel
1pc* A pair of gloves
1pc* Googles
1pc* Ear plugs
1pc* Air hose
1pc* A set of fitting of blasting gun (Flathead pipe, 50cm bent pipe, 35cm bent pipe, 35cm straight pipe,  50cm straight pipe)